Wiring Diagram

R

RonT

Member
Joined
Aug 31, 2018
Messages
32
Location
Maine
Parked the 05 Wrangler X, 135,000 mi, next morning it would turn over fine but no start. CEL Codes were P0108, P0335 and P0340. The research I did steered me to the Cam Position Sensor. I have a three wire system and apparently one wire stays hot coming from the computer, I did have the ignition in the run position. Using a test lamp I did not find a hot wire at the harness connection so somewhere I have a short.
Can someone tell me how and where to get a wiring diagram so I can do some tracing?
Thank you for your help.
 
Unfortunately I don't have this electrical schematic to view but if its an input wire from the ECM isn it a 5 volt reference wire which will not light up most average test lights("test lamp")? you will likely need a digital volt meter
 
Top Bottom
Back