Latest activity Postings Images About
-
-
IOwnCalculus replied to the thread '03 TJ Trans/T-Case Vibration during Acceleration."Slower than engine speed, higher than tire speed, roughly triples in frequency in 4LO" all sounds like it's either output-side of the... -
IOwnCalculus replied to the thread Arizona Tow Pigging Daily Driver.Yep - even the best surge brakes are worse than electric brakes. The only part on that I might be a bit spoiled on is I've never towed...
-
IOwnCalculus replied to the thread New Cloyes timing sprocket (crank side) is too tight.It's been going on longer than just a year, too. I bought a Cloyes set from OReilly in 2020 that had the exact same "crank sprocket too...
-
IOwnCalculus replied to the thread Arizona Tow Pigging Daily Driver.Yup, can't argue with a solid copper license plate. My TJ still has three years to go.
-
IOwnCalculus replied to the thread Arizona Tow Pigging Daily Driver.Copper plates have zero restrictions other than 25 years old, and provide no benefits other than looking good. The emissions exemption...
-
IOwnCalculus replied to the thread Viair 88p on ABS tray - have a couple questions.So far so good, but I also view it as "if it dies, it dies". If it ever does give up the ghost I'll redo it with a Viair actually...
-
IOwnCalculus replied to the thread Front differential leak, should I just redo the RTV?.Thirded. They're reusable (within reason) and it makes future fluid changes much faster since you cut out the entire razor blade / wire...
-
IOwnCalculus replied to the thread Viair 88p on ABS tray - have a couple questions.I have mine hard-mounted to the ABS tray but apparently I've never taken a photo of it. I bolted it down, I want to say I used at least...
-
IOwnCalculus replied to the thread Weird electrical gremlin.To be fair, I discovered this a couple weeks ago when I hooked the battery back up on mine while the grille was still on the ground.
-
IOwnCalculus replied to the thread Weird electrical gremlin.The ground at the front left of the engine bay is disconnected - factory setup is a ring terminal on a 10mm screw going into the back of...
-
IOwnCalculus replied to the thread NV3550 replacement shifter options.The closest thing I have to a complaint about the B&M is that between the TJ and the Ranger previous to that, the only manuals I've...
-
-
Loading…
-
Loading…
-
Loading…