Abendage's latest activity
-
Hey guys, just wanted to give some updates on the spring. I was able to get some new spring sent to me and was able to swap them out... -
Rode 101N to Santa Barbara, then up through Los Olivos to Santa Maria, then down to Jalama Beach for a burger. Great ride, great burger...
-
Abendage replied to the thread What did you do to / in your garage / shop today?.Not a lot of work going on today.
-
-
Abendage replied to the thread My towing predicament.Lasso straps. Either over the tire or through the wheel.
-
-
I had to add a 1/4 inch spacer under the passenger side to get things where I wanted them. I ended up with 6 1/8 inch up on one side and...
-
I’ve wheeled with you… this needs to be a flag on your jeep! Interesting about stickies and 44’s hadn’t even thought about that...
-
Abendage replied to the thread Fox Tuneable Shocks.Gotcha, travel and dimensions are the same and I think it’s the only one on the market with 5/8 shafts so probably the new way to go.
-
Abendage replied to the thread Help with 2000 5.3 LS block and 2004 ECM / harness.The 2000 would have had an EGR valve and I don’t think the 2004 did, but other than that I think you should be fine. I think it’s ICT...
-
It looks like the beloved Factory Race series 980-02-039 and 034 have been discontinued and replaced with the Performance Elite series...
-
Abendage replied to the thread New lift riding a little too stiff!.Specs don’t matter. How much uptravel you have and your travel bias matters. A lot of the issue could be too long of shocks and...
-
Abendage replied to the thread New lift riding a little too stiff!.Your shocks seem long for 3.5” of lift. x4, Rs5000X are the opposite end of the spectrum you are looking for and spray paint.
-
Abendage replied to the thread Rock Sliders / Rocker Guards Guide.And I’m another 90 minutes past you!
-
He's not willing to drive. I've offered up my entire shop and tool collection for his use, and the 90 minute drive is too far. Kids...
-
Abendage replied to the thread Rock Sliders / Rocker Guards Guide.If you feel like making the drive, I have the rotobroach set, 17/32 drill bit you’ll need, and 2 different setting tools you can break.
