Latest activity Postings Attachments Images About
-
-
Props to @hosejockey61 for always helping out with these along with @Blackjack too. Not everyday you get a world renowned youtuber and... -
No reason for me to do that. Find a place that sells out of date lifting slings. They are way overbuilt for what we need, they are...
-
JDM replied to the thread Freedom winch line 3.0 from the Bleepin Guy.I’d love to see Wizard Recovery Gear offer a tree saver . I have trust issues with the majority of tree savers that I see mass marketed...
-
Got to give him credit though. They used the same marketing to convince folks that more connections are better in the same way that big...
-
Answering off my phone so I’ll have better replies if needed after my practice. But after driving the Jeep home from work I disconnected...
-
True enough. Hopefully have enough time to bring it in tomorrow and get it tested, then start digging into the wiring more. I will...
-
JDM reacted to PNW_LJ's post in the thread JKS vs Rough Country quick disconnect comparison with
Like.
Perhaps their motor mount lift spacers? Pretty hard to mess that up. -
JDM replied to the thread Deep water hole woes.If you try cranking it , you’ll still be wondering if it is a starter issue . If you take it to have it load tested , you’ll either...
-
JDM replied to the thread Deep water hole woes.Try charging the battery and then have it load tested at your local auto parts store . Sounds like you have a shorted cell .
-
JDM replied to the thread Drive Line Measurements Question.Just be sure to check the measurements at full droop . That will be the shortest your driveline will see . You don’t want the driveshaft...
-
JDM replied to the thread Drive Line Measurements Question.My measurements were for center of front ujoint to center of rear ujoint . These measurements are slightly longer than measuring yoke to...
-
JDM replied to the thread Drive Line Measurements Question.I have the same mods on a 2002 automatic . I set my pinion angles before I ordered my new driveshafts . The front measured 39-7/8 . The...
-
JDM replied to the thread Marker light sample tester(s) needed.I temporarily installed Mr Blaine’s new marker light’s yesterday . Still deciding on final placement . I can say they are definitely a...
-
-
JDM replied to the thread Hollerwood - Stanton, KY.Coming up out of the creek at Jimmy’s Bend in Hollerwood
-
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
