Recent content by TryHqrd

I'm working on re-gearing my rear dana 44 (Just blew it up) and got a ring and pinion from marketplace for a dana 44 trac lok. I did not know that the 03-06 models (54703 from catalog) were different then the 02 diff that I have, the holes are 7/16"-20 insead of 3/8"-24. Would I be able to drill...

Hello, I currently am having problems with my NP231, it started around 2 months ago with a clicking noise while coasting in the Jeep, then it became very bad driveline vibrations last weekend, when I inspected I noticed that the rear driveshaft U-Joints are bad and had partially damaged the...

So I ended up needing to pull the harness. So far I've only found one cut wire. Also I tested resistance between the terminals with a continuity testing probe and the light lit up, is that supposed to happen? Finally I did the alternator test where you remove the negative battery cable and see...

What I was trying is to take a multimeter and measure resistance while flexing the harness to see what gives a reading of zero or near zero.

I have an 02 TJ that has been running into some electrical problems lately. Around 2 weeks ago I was trying to fix my check engine light which blew the fuse to my O2 sensor heaters. I found that one of the downstream sensors had a short in the heater element on the harness side of the connector...

You guys are going to love my $350 used long arm lift kit and my $350 set of 4 35s plus spare lmao

Alright you guys convinced me, I’m going to start with the two upstream sensors and then finish up the lower two in a week. Thank all of you for the help even though deep down I was kinda hoping everyone was gonna go “idgaf buy em” :)

It’s $47 for all four, it’s dangerously cheap and I know lots of people are afraid of chineseium O2 sensors but I don’t want to drop the $150 if I can (Imma broke college student btw) Link: https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.com%2Fulk%2Fitm%2F122989660820

Custom Bumper I wanted mine a little shorter but I do have CAD files if you would like to try it out

Custom Bumper I wanted mine a little shorter but I do have CAD files if you would like to try it out

I’m in a university right now and I can verify that some of the kids in my aerospace classes have only joined for the money and I can’t wait for them to realize no matter what degree you get it won’t make money drop in your lap, believe it or not it takes hard work to make money.

Thanks for the advice! My idea if it has any interference with the tip of the bumper then I would remove plates 4, 5, and 6 and replace them with a flat plate instead.

Thank you! I’ll probably will wait a bit so the bumper matches my jeep

Yes, but that will be farther down the road, it also might require beefing up.

I already asked some people their opinion on my bumper but I want to see what you guys think. I still need to grind and paint but I wanna see if I need to make any changes first. Also if anyone wants the design files I can share it with them (They aren’t very easy to follow but I do have them)...