txbemis69
was last seen escaping the asylum 58 From east texas
Latest activity Postings Images About
-
-
txbemis69 replied to the thread Front wheel spin when in 4WD.typical for an open differential, looks odd though when seeing it for the first time. -
txbemis69 replied to the thread Turn signal works, but running lights don't - Question.check all of your grounds around your headlights. make sure they’re clean and tight.
-
txbemis69 replied to the thread Wiring a hardtop for my 99 TJ.look in the resources section, there are service manuals for the different year models that should have wiring diagrams/chematics. hope...
-
txbemis69 replied to the thread Does this gap seem appropriate around the door?.they were hard to come by that’s for sure. not sure what a good alternative to oem would be if oem can’t be sourced.
-
txbemis69 replied to the thread KO2 Sidewall Cracking.hell they look like new other than the slight cracks.
-
txbemis69 replied to the thread What is the best coil spring for my usage?.if you go with ome springs look up dirk at dpg offroad. he’s very knowledgeable on the ome stuff.
-
Thanks for the replies. One more quick question.....I read about using a ratchet strap to help line up the axle bolt hole if things...
-
The only adjustment that may be required is centering the steering wheel depending upon the positioning of the old trac bar vs the new one.
-
txbemis69 replied to the thread 2005 Exhaust Manifold (Replacement Advice).did not remove the fender only the rubber inner part. no way to get a torque wrench on a couple of the bottom bolts. could only get a...
-
txbemis69 replied to the thread Kill Switch Fuse.as a 16 yr. old kid i parked my new to me 76 datsun280Z in front of my parents house on a slight hill. walked off and turned to admire...
-
txbemis69 replied to the thread 2005 Exhaust Manifold (Replacement Advice).you’re right about the bottom bolts being a booger. lots of colorful words went into getting the bank’s piece fully bolted in place.
-
txbemis69 reacted to KennethS's post in the thread 2005 Exhaust Manifold (Replacement Advice) with
Like.
I replaced the factory manifold with a Banks Engineering stainless steel header, which made accessing a few of the lower bolts more... -
txbemis69 replied to the thread Track bar install help.it shouldn’t be.
-
txbemis69 reacted to Jerry Bransford's post in the thread Sadly, my Jeep burned down. Anyone want free parts? with Like.
My then still nearly new '97 TJ's catalytic converter caused a small brush fire that I was barely able to extinguish somehow without a...
-
txbemis69 replied to the thread Center console subwoofer.what this guy said is what got mine to working after swapping out the factory head unit.
-
-
Loading…
-
Loading…
-
Loading…