STICKY Share Your 3D Design Files (or Sell a DIY Part)

Not mine, but ran across a replacement manual transmission shift bezel for '05 and '06 that purports to permit using a rubber accordion boot instead of that stupid bag we've been stuck with. Gonna give it a try...

https://makerworld.com/en/models/2884419-jeep-tj-shifter-boot-bezel-for-2005-2006

Totally missed that. Thanks for pointing it out!

hey @dearchristopher I looked and saw none of my stuff from this thread's on the site. How can we/I upload?

Mogul345 said:

hey @dearchristopher I looked and saw none of my stuff from this thread's on the site. How can we/I upload?

Click to expand...

Good looking out! I've been in a busy season of life and haven't had a lot of time to improve the site, but there IS a submit a part option at the bottom of the site in the footer. I'm going to see about adding a bulk part submission, but also I'll run a scrape on this thread and get you loaded up on there!

I'll add my most recent addition.

As we all know - synthetic ropes get destroyed by Texas sun, but winch bags trap moisture and generally look horrible. I didin't want my new Wizard Recovery rope to suffer a premature death, so I came up with this:



I made 2 versions, one with a downwards facing plate to help cover some of the light getting in between the cover and the fairlead, and another that just covers the top. This design is for a Smittybuilt Gen 2, but I don't see any reason the same principle couldn't be taken to most side mount winches. OBV this still lets in some light at the back and through the fairlead, but It should greatly reduce UV exposure while still allowing the winch to breath and not looking hideous. I went with PETG for the final product, so far its held up fine to 2 days in Texas summer.





Feel Free to share and print for Free, if someone wants to start selling them PM me and we can works something out. I also have the F3D's if you need a modified version.

Jezza said:

Bumper end caps for the OEM bumper. 3d printed in ABS and painted along with the bumper. Drill in place and attached with 1/4-20 button heads.

https://www.printables.com/model/254989-jeep-wrangler-tj-bumper-end-cap

View attachment 349123

View attachment 349130

Click to expand...

Did you paint these as well?