Search results

Has anyone removed the third downstream catalytic converter from their 2003-2006 TJ? If so, are there any benefits or side effects from the removal?

Well, this past weekend, i noticed a clunking sound from the front end of the jeep and realized that I have not yet replaced my front control arm bushings at the axle. I recently replaced motor mounts, and front drive axle shafts due to bad u joints and excessive front end noise. The motor...

Well, every once in a while I get this notion about selling the old jeep in pursuit of who knows! I am sure this thought has crossed the minds of many and despite our love for the Jeep TJ. I am currently made an offer to sell my Jeep and I am not 100% sure of what to do. I have owned the Jeep...

Well, I narrowed down the dash vibration to worn motor mounts. This weekend I crawled underneath the Jeep to have a look and realized that the driver side will be somewhat challenging. Any helpful hints on how to attack this project?

Merry Christmas to all Jeep enthusiast and your families

Just got the TJ aligned after replacing all the tie rod ends. Any thoughts.

Anyone using aftermarket front axle shafts? Chromoly or Spicer? any issues with aftermarket?

Well this morining while driving my jeep TJ to work, heard a loud thunk and consistent tic and stopped the jeep only to notice that my front axle u-joint missing one of the end caps. WTH! What caused this to happen? Not sure but should I replace the whole shaft or just repair the u-joint?

So, after replacing my cats about 2 years ago and driving my jeep 4.0 as my daily driver in the Las Vegas heat, I came across the dreaded p0432 code recently. This code indicates a possible failure at the second bank catalytic converter with many possibilities. So I began the research into why...

recent wheel alignment….any suggestions? Jeep TJ 6 “ lift

What size rims and tires do you fancy most and why?

Yet another wheel alignment ! Any suggestions for rear thrust angle and toe in? RC 6” and 35s . Don’t hate on my lift just make some knowledgeable recommendations please.

I got a wheel alignment yesterday! Jeep drives like shit as usual, all over the place!

My lifted Jeep with 35’s aligned and tightened up, still swaying side to side, front end with speeds above 45-50. Any additional ideas will be greatly appreciated.

Anyone know a reliable and competent alignment shop in Las Vegas Nevada?

Can too much toe in cause bump steer?

Just re adjusted my control arms and got an alignment. 6” lift with 35s. Any thoughts ?

I just adjusted the front control arms lower and upper and got an alignment, any feedback is much appreciated. I am worried about too much castor! Any thoughts ?

Any TJ owners in Las Vegas ?

Any thoughts on drop pitman arm use for 6” lifts?