Search results

Hey guys, I replaced my PCM the other week. The emissions drivers were dead. I have a 2006 Rubicon manual trans. The code I'm getting is P0888. As far as I can find this code is for a automatic trans. Am I wrong? Is there a fix I can do before I scream and yell at a Sales people?

Every gear at all speeds.

I'll get a video posted on Monday

Oil is at the pug. Stuck my fingers in and its maybe just below but its full

So my Rubicon 06 6 speed transmission is roaring. It almost sounds like tire noise but it's not. Only when it's in gear and power is being applied do you here the roaring noise. I push in the clutch or put it in neutral and there is no noise. It's not engine noise, not diff noise or tire...

What do you guys think about outer axle seals? They keep junk out but do they support the axle any while wheeling. Are they worth the time?

What company did you buy the seals from? I messed up and bought through Ebay. I didn't get the template.

Seals, the ones in the pumpkin.

Yes, the inner seal.

How often do axle seals go out in a dana 44. I don't wheel hard but I'm on my way to doing so. My front passenger seal is leaking, is it worth buying a seal tool or just improvising something to set the seal? I'm doing the work myself. I have more time then money to pay someone else to do work...

I'm talking about the one joint on most lift kits that look like an OEM part

How fast or often do clevite ball joints go out. I'm wanting to buy a lift and am wondering if the extra money for a metalcloak system is worth it?

No, after turning off the heater it will crank up with no problem. With the heater left on it wont do anything

Battery terminal are clean and tight

Because it's only happened twice I dont know the speed or RPM. I can say that has happen both time while I slow down. Once coming to a red light the other turning into a side street.

The 06 Rubicon 4.0 has electric power but the engine shuts down while driving. The power to electrical is there but the starter wont turn. Both time the heater has been running and both time after the heater is shut off the starter will turn and the engine will run as normal. Any one heard of...

What are pre cats? Are you saying I need to replace my cataLytic converters. I thought the code for catalytic problems was P0432.

100k

Factory

All four codes are coming up on my 2006 Rubicon P0135 P0141 P0155 P0161 I've changed out the sensors with NTK sensors. I've sent the computer off to SIA Electronics and they reported the ECM is fine. Any ideas to get me going. The codes come on all at the same time.