Search results

Hi all, just replaced my TJs rear disc brakes with new pads and rotors and I noticed even after break in I’m getting the burnt brake smell. After driving I checked caliper temperatures and they were both around 390F whereas the fronts were at 110F. I’m guessing that for some reason there is...

Hi all, Picture attached but due to a shortage of spicer 709644x ball joints, went with the Yukon ones, but to my surprise the lower joint had a Zerk fitting…in a test fit with just sliding the axle in, it looks like it either just barely clears or just barely hits, so my question is do I...

Selling set of 5 D load rated BFG KO2s 37x12.5R17 with 14/32nds of original 15.5/32nds tread left, less than 10k miles…went smaller to make family happier with jeep 🙁. DC area (Bethesda MD).

Selling set of 5 D load rated BFG KO2s 37x12.5R17 with 14/32nds of original 15.5/32nds tread left, less than 10k miles…went smaller to make family happier with jeep 🙁. DC area (Bethesda MD).

Ok, initial search didn’t find this, but after replacing the parking brake equalizer bracket, and adjusting them, I noticed that the driver side wheel is locked tight with no movement when engaged, but passenger side is allowing just a little movement back and forth of the wheel before stopping...

Hi all, hoping I can get help…checked a few of the suggested threads but not all so apologize if missed this… Replaced fuel tank with a genright unit, but in pulling the sending unit, in the bottom of the old tank was a rectangular what looked like filter material, but it doesn’t actually seem...

Hi all, don’t believe all parts of this have been discussed, but redirect if I missed something in my search. Took jeep in for alignment with Firestone and they suggested new unit bearings…which is very early. Took it home, raised it and tested, and a lot of play in the drivers side but none...

Anyone know a belly up kit that would work with an Atlas 4speed? When I first got the four speed I also got a belly up kit and was told it would fit…but it didn’t due to the extra length on the four speed. The shop said they could try cutting it down, but ended up sticking with the stock...

Ok, so there are numerous threads on axles and 37 inch tires…but I swear this one is a bit different, so please be patient and read. I have a 2001 TJ, with 2003 Rubicon axles, and can honestly say my jeep was most likely the first ever (or one of the first) non test jeeps to replace the 2001...

Hi all, I'm praying someone can answer my questions...but first and foremost, I have done the precursory checks, and the collar on the drag link is tight, there isn't any play I've seen in the track bar or tie rod ends (although going to relook), with that said, here's the rest of the story...

Hi, not sure where this thread has gone and if this has been answered, but I currently have a 4.5 inch RE express from 2002, on a 2001 TJ wrangler with rubicon axles from 2003. I actually want to go lower on the lift, was looking at 3 inch savvy progressive springs, but was curious if I would...