Search results

Is the vacunn line next to the resistor under the glove compartment?

Boinked, I was not familiar with that resistor. There is one resistor under that glove compartment are that I checked and its good. it appears like the blower will not kick on at all. Could the resistor cause a this issue?

OK so I tested the relay and its good. Not sure what else it can be

Ok guys, so my 2000 TJ AC was not blowing through the vents. It was determined that the blower was bad. I replaced the blower and when I turned the ac on I could hear a noise only on 3-4 speeds. Took the blower out to inspect and all was good. Re installed the blower and noise was gone but lost...

Ok, so I replaced the blower on my jeep. Whe I started the jeep up the new blower was making a loud noise on the higher speeds. I removed the blower again to inspect and everything looked good. I re installed and now only appears to work on the 1st speed but not the others? Bad switch? Bad...

Thanks Jerry! Found a Youtube video. What would this world be like without youtube lol

Is it behind the battery?

My TJ is a 2000 jerry

Not too bad just want to make sure it is indeed the motor

No Jerry, no change of tone

Thanks Chris! Any idea on the cost?

Yes Chris the same on all speeds

ok guys, Im experiencing yet another issue with my jeep. The A/c blows very weak even on high. The little bit of air that is coming out is cold but very weak. What can be the problem? Bad resistor? Bad blower? Thanks in advance

Thanks guys, much happier

Ok guys, installed the bds 3 inch springs. No more vibrations and I think looks better

Rob, thanks for your feedback and very helpful by the way. I currently have 4 inches of lift and going down to 3 inches will certainly help in my opinion. I do have the transfer case drop. Also, the vibration I feel is between 30-40 mph then goes away.

The more I read the more it appears that in order to get rid of the vibrations I need to shell out at least 800.00. Or I can get 3 inch lift springs for 200.00 and hope that eliminates the need to change the shaft and sye. Decisions decisions, by the way I was running 35s with stock suspension...

Ok, I measured the transfer case spacers and they are approximately 1 1/2 inch

I will measure shortly! The lift is starting to grow on me. The more Iook at It the more I like it. Vibration is not unbearable but Im concerned something will fail over time

Not spending sorry typo