Search results

I am not getting heat into the cab. I have flushed the entire system, back walked the heater coil, checked that the door is opening at the fire wall,(it is), i do not have water in the cab or under the Jeep (in case, coil was cracked),I don’t have any more ideas?? Any body?

So, I completed my rework and upgrade this past Saturday. (Very long Saturday LOL). Following Tj Forum posts, I replaced all four ball joints on my 1999 TJ using the recommended Dana/Spicer 706944X ball joints, rented a ball joint press from Advanced Auto and bought the adapter along with all my...

Yep. That’s what I figured all along. Saw that one from crown as well. Thanks for your help.

Yep

Yes I bought the upgrade zj I already have one sleeve. So if I just get another sleeve it should work then? I know which sleeve number it is and I can get it at advanced auto without having to wait on amazon..... for 10 bucks more lol

BTW, Amazon has two Currie units, ones $460 the other one is $550. Can’t tell the difference. Do you happen to know?

That’s a work of art!! According to the post. I only needed one adjusting sleeve and that’s at the pitman arm. That what started by whole conversation. The recommended tie rod has a tie rod end permently on it and a threaded male at the other end. So I figured I needed another sleeve. Chris is...

Thinking I should have just bit the bullet and bought the Currie set.

Thanks Blue. I’ve seen this pic before. I can’t figure out what I missing??? Just not getting it I guess.

Ok, so I was correct in my assessment. I’m 100% with the drag link to the pitman arm with a couple to attach the tie rod. This is where I am losing the connection. The tie rod we just discussed has a tie rod on each end. One is already on the new tie rod with the other end threaded. How am I...

Ok. I figured that was the case when I ordered. So the rod in this picture attached is NOT getting replaced?

Chris, just took these photos. And pic of tie rod I bought from amazon. Tie rod is not the same. Amazon also states that it will not fit my 1999 wrangler? What am I doing wrong. BTW, thanks for your help with this. Paul

Hey Chris, so I got all my parts as suggested for the conversion. I’m sitting in my kitchen as I will be doing the job this Saturday. What could be a really stupid question on my part but....... I have the two different tie rods, I have two of the same tie rod ends and I have ONE coupling, how...

Thanks Rob, I’ll shop those out.

Truck has a 4.5 lift from previous owner. They did do upgrade to steering linking and tie rods. But it this point, I know one end needs to be changed and the driver side ball joints so, figured I change all the tie rod ends while doing the ball joints. One member recommended MOOG.

So I watched the thread about replacing ball joints and have to say it was great. Clear and concise. Love the fact that you recommend decent parts. With that said,since I will be doing the break down,figure I will replace tie rod ends at the same time as the ball joints. Any recommendations for...