4 inch lift

  1. J

    Going from 4" lift to 3" lift?

    Hi all, first time poster long time reader. As the title states I'm playing with the thought of going from a 4" lift to 3" suspension lift. Picked up a 2000 wrangler sport that has a bare bones 4" RC lift with a 1" t-case drop. Currently running 285/75 16s with 1.5" spacers and stock steering...
    • Je.m8792
    • Thread
    • 3 inch lift 4 inch lift lift concerns lift kit recommendation suspension tj
    • Replies: 17
    • Forum: TJ General Discussion
  2. L

    Rubicon driveshaft vibes

    I have a 2005 Rubicon with a 4 inch lift (probably Rough Country). The transfer case is lowered one inch, probably from Rough country too. All from the PO. There is vibration at around 70 MPH. It's done this since I bought it and It seems to be getting worse. I will be checking pinion...
  3. Tim_with_the_tj

    Who’s running Metalcloak coils?

    Anyone with a light TJ (4cyl, soft top, half doors) running the Metalcloak 3.5 inch coils? Very curious how much actual lift I would get. I haven’t been here long, but it’s been long enough for me to see some of you speak up about disliking Metalcloak coils. What I like about them on paper is...
    • Tim_with_the_tj
    • Thread
    • 3 inch lift 3" lift 3.5 inch lift 3.5" lift 4 inch lift 4" lift coil springs coils currie metalcloak metalcloak coil springs metalcloak coils savvy
    • Replies: 48
    • Forum: TJ General Discussion
  4. BigYellah

    Pennsylvania 4 inch Springs and/or sway bar ends to match

    Removing my 4 inch lift, so I'm going to get rid of the coils and sway bar end links. Both have surface rust on them, all 4 coils look almost identical to the ones pictured. Back measure a perfect 12 inches, front measure 16. No sag, perfect operating condition. The end links look a little...
  5. BigYellah

    I need help going full Sherlock Holmes on 4 inch lift control arms

    Hi all, thank you very much with helping me figure out my front steering components the other day, it was greatly appreciated. With that said, I need help figuring out what I need to replace for an appropriate 2 1/2 inch lift, from my current 4 inch lift. I ideally would like to run 31's and...
    • BigYellah
    • Thread
    • 4 inch lift control arm identification down sizing help moving to 2 inch smartest move
    • Replies: 17
    • Forum: TJ General Discussion
  6. BigYellah

    I Need Help Identifying Front Steering Components From Previous Owner

    Please help! Hi everyone! I just bought the Jeep about 2 and a half weeks ago, after thinking about one for years. I absolutely love it, it only has 73k miles, no body rust, and an unreal solid frame for the north east (which I just POR15'd after lots of thread reading!)... However, it needs...
  7. Sbaird

    Do my camber bolts need to be adjusted after installing 4 inch lift?

    Just recently finished up my 4 inch suspension lift by Rough country, I know I’ll need an alignment but I also need my camber bolts adjusted I believe. I don’t know much about how the camber bolts work or how to adjust them, I had to put new ones in because I had to cut the old ones out when...
Top Bottom
Back