Hey Team,
My bracket on the axle tube of the driver's side is bent inward. I'm installing the Currie Anti-Rock but if I install it as per the instructions the joint makes contact with the spring.
Is it alright to install it with both bolts facing inward (as pictured)?
I tried straightening the bracket with a large plumber's wrench and it bends but just goes back in to place. If I were to apply heat via a torch or something would that work to permanently straighten it? Or is it not worth the hassle / potential to snap?
Thanks for any input!
My bracket on the axle tube of the driver's side is bent inward. I'm installing the Currie Anti-Rock but if I install it as per the instructions the joint makes contact with the spring.
Is it alright to install it with both bolts facing inward (as pictured)?
I tried straightening the bracket with a large plumber's wrench and it bends but just goes back in to place. If I were to apply heat via a torch or something would that work to permanently straighten it? Or is it not worth the hassle / potential to snap?
Thanks for any input!