Currie Dana 60 Question

[FTI76]

The TJ rear HP60 has the following notation. Is anybody familiar with this? Is that a better alternative?

*I appreciate all of the knowledge on here but my mind is already made up on the HP44\HP60 combo

https://www.currie4x4.com/currie-60-high-pinion-jeep-tj-lj-rear-axle

Sway Bar: The factory TJ/LJ rear sway bar must be flipped side to side (installed upside down) to be used with a high pinion Currie 60. However, due to its design, the factory sway bar will interfere/limit the housing's downward travel at full droop.

 

[Apparition]

Ideally you want a rear antirock on the 60.

The sway bar will be problematic under the housing. Mine is currently under the housing so I’m familiar.

 

[FTI76]

Ideally you want a rear antirock on the 60.

The sway bar will be problematic under the housing. Mine is currently under the housing so I’m familiar.

Thanks! I just found another thread on this and was going to delete the but can’t figure out how…