Currie Spring Sag

[JMT]

So, earlier in this thread I stated that was replacing my Currie front springs because they had "sagged" over time. I based this on two things: first that I was only getting about 3 1/4" inches of lift and when I measured the free length it was close to an inch shorter than spec. Well evidently my ruler reading skills leave a lot to be desired. When I pulled out the old springs today they were exactly the same length as the new springs I had just received, and both were as long as specced. After I installed the new springs I had exactly the same lift as the ones I removed.

Evidently I was wrong when I stated my springs had sagged. My apologies to Currie.

So, are you going to sell the used Currie springs?

 

[LowRange]

So, are you going to sell the used Currie springs?

I might as well. I don't need both. Shoot me a PM if your interested in purchasing them.

 

[JDRAM11]

I have the CE-9131RH3P as well and my driver side has a 1/2in sag, @LJGreg did you fix your issue? im considering replacing the springs under warranty.

 

[LJGreg]

No I still have a slight lean but haven’t put any energy into fixing it yet. I would be more inclined to buy a small spacers for the short side than deal with warranty.