Took skid plate off for muffler job. Lower plenty of times without issue. This time, engine dropped way to far without support - yea I f up. Now, it won’t go back up. If you jack up the trans/engine back into place it will just stay in the down position to the point that the whole Jeep will come off the ground. I’m screwed!!!
I’m thinking maybe rear shaft binding or something in engine bay catching due to how far it dropped. Motor mounts are intact but rubber bushings are stretched.
Any ideas how to get this back in place?
2000 Tj 5speed
I’m thinking maybe rear shaft binding or something in engine bay catching due to how far it dropped. Motor mounts are intact but rubber bushings are stretched.
Any ideas how to get this back in place?
2000 Tj 5speed