Hello,
I just finished a two hour drive without issue. When I started my Jeep to go home I made a few dozen yards before the engine bogged, then came back, bogged, came back. I limped it to a parking lot. I started it again and it idled fine for a few minutes, then it started alternating between trying to die and revving up.
I ran my scanner and got the following codes:
P0138 Heated oxygen sensor 2 bank 1 high voltage
P0132 Heated oxygen sensor 2 bank 1 high voltage
I'm reading online that this could just be a faulty O2 sensor but I've had that before and it didn't have that problem. It also said might be a leaky fuel injector.
Can anyone shed some light on this? I'm currently stuck in a parking lot two hours from home. No check engine light.
1999 Jeep Wrangler 4.0.
Update: started it again, idle is rough but it can move, however my AC panel isn't working. I can't turn on the blower on any selection. I hear a slight hiss when I try to turn on any of the settings but zero output.
I just finished a two hour drive without issue. When I started my Jeep to go home I made a few dozen yards before the engine bogged, then came back, bogged, came back. I limped it to a parking lot. I started it again and it idled fine for a few minutes, then it started alternating between trying to die and revving up.
I ran my scanner and got the following codes:
P0138 Heated oxygen sensor 2 bank 1 high voltage
P0132 Heated oxygen sensor 2 bank 1 high voltage
I'm reading online that this could just be a faulty O2 sensor but I've had that before and it didn't have that problem. It also said might be a leaky fuel injector.
Can anyone shed some light on this? I'm currently stuck in a parking lot two hours from home. No check engine light.
1999 Jeep Wrangler 4.0.
Update: started it again, idle is rough but it can move, however my AC panel isn't working. I can't turn on the blower on any selection. I hear a slight hiss when I try to turn on any of the settings but zero output.