I have an 03 TJ, 2.5” lift, fixed aftermarket lower control arms, stock uppers, no SYE or BL. Stock rear track bar with straight relocation bracket. It’s rubbing on the fuel tank crossmember and skid plate stud. I recently discovered the relocation bracket is dangerously close to the fuel and evap lines and has broken the retaining clip on the evap line (already addressed the clip).
I’m looking at the Metalcloak 7046 track bar.
Has anyone installed that track bar with a similar sized lift without the relocation bracket they send with the track bar?
I also see they sell 7096 without the bracket but it specifies it’s for long travel suspension. Would the 7096 work with a short arm lift?
I understand the relocation bracket helps with roll center but I have also heard at smaller lift sizes it’s not much of an issue.
I’m looking at the Metalcloak 7046 track bar.
Has anyone installed that track bar with a similar sized lift without the relocation bracket they send with the track bar?
I also see they sell 7096 without the bracket but it specifies it’s for long travel suspension. Would the 7096 work with a short arm lift?
I understand the relocation bracket helps with roll center but I have also heard at smaller lift sizes it’s not much of an issue.