PH4 Bits

[Tob]

It is almost impossible to get them tight enough without cam out ruining the fastener if you do it manually.

Ah, ok. And just for my understanding, limited fastener selection makes Phillips the best overall selection as opposed to something like Torx?

 

[Longwhitejeep]

Don't forget he uses metric Torx drive.

Thanks! Confirmed that on a test fit. I debated on switching the savvy sliders to torx at some point.

Any recs for the torx bits?

 

[mrblaine]

Any recs for the torx bits?

Not really.

 

[mrblaine]

Ah, ok. And just for my understanding, limited fastener selection makes Phillips the best overall selection as opposed to something like Torx?

I prefer and do use Torx but I have to make them from longer screws that are too expensive for the average joe.

 

[Longwhitejeep]

I finally broke th genius bit working on tightening up savvy skid. It was a bit noisy last time out.

I’ll order a few more and maybe try the wera or lisle too

 

[JMT]

I finally broke th genius bit working on tightening up savvy skid. It was a bit noisy last time out.

I’ll order a few more and maybe try the wera too.

I loved the genius one, till it burned up in the fire. I forgot. I need another one.

 

[Longwhitejeep]

I loved the genius one, till it burned up in the fire. I forgot. I need another one.

Same! Snapped it after many uses. I was using on my racket though, trying not wake the kids up