So I bought a mostly finished Wrangler project. I'm close to driving it but have a few things I'm unsure of.
The PO swapped in a 5.2l, nv3550, and a np249. To those who've done this swap:
How did you get your reverse lights working? Or where are the wires for it?
Also from the pictures that I've attached, did they mount the engine too far forward? The shifter is a good bit forward and I need a longer rear driveshaft. There's about a half inch I can side it back on the mounts.... Doesn't seem like enough. And on the driver's side the mount is backed up to the steering bracket.
Sent from my LG-H918 using Tapatalk
The PO swapped in a 5.2l, nv3550, and a np249. To those who've done this swap:
How did you get your reverse lights working? Or where are the wires for it?
Also from the pictures that I've attached, did they mount the engine too far forward? The shifter is a good bit forward and I need a longer rear driveshaft. There's about a half inch I can side it back on the mounts.... Doesn't seem like enough. And on the driver's side the mount is backed up to the steering bracket.
Sent from my LG-H918 using Tapatalk