My locker pumps quit working, as in won't turn on at all, and after some online searches I decided that I'd at least try to take it apart to figure it out. I found a thread on the Rubicon Owners Forum that said to remove the square metal plate on the bottom (you basically pry 3 sides loose and then pop it off) and it would reveal the circuit board.
When I did that I noticed that one of the circuits was broken (see the copper colored foil in the pic). I used some 18g wire to solder in a jumper between the two points and got it to work again. I looked at my other pump and it was the same thing...both fixed now. Easy fix and only cost me about $25 for a low end soldering iron at HD.
When I did that I noticed that one of the circuits was broken (see the copper colored foil in the pic). I used some 18g wire to solder in a jumper between the two points and got it to work again. I looked at my other pump and it was the same thing...both fixed now. Easy fix and only cost me about $25 for a low end soldering iron at HD.