Turn signals not working while pushing on the brake

B

Brett

New Member
Joined
Oct 3, 2018
Messages
3
Location
Indiana
so for the last year my turn signals have not been working on my 2000 TJ. The turn signals work perfectly fine until I put my foot on the break once the brake Is applied it acts like my hazards are on. I have replaced the relay and checked the fuse in the glove box but it still does not want to work. Any ideas?
 
Last edited by a moderator:
Check and see if all the bulbs are the correct bulb, and they are installed correctly. I have had instances where the filament inside the bulb became unattached at one end, and attached itself to the other filament, causing a back feed in the circuit causing the symptom you are describing.
 
Mrhp said:
Check and see if all the bulbs are the correct bulb, and they are installed correctly. I have had instances where the filament inside the bulb became unattached at one end, and attached itself to the other filament, causing a back feed in the circuit causing the symptom you are describing.
Click to expand...
That sounds like an easy place to start. I will definitely look into that. Thanks!
 
Top Bottom
Back