Attached to back of hvac selector that changes from heat to A/C and beside the colored lines. I can’t find where people have mentioned its name or where to get a replacement connector.
What is this wire called? HVAC
- Thread starter Gary2000TJ
- Start date
Not sure. The videos I’ve seen were all about replacing the blower switch but my connector to it looks good. People had mentioned replacing the switch, the resistor and blower motor but have seen anyone mention what to do to replace the melted wire connector. No time to look at a junk yard.
From my 06 FSM:
And it's melted because your blower motor is drawing too much current.
And it's melted because your blower motor is drawing too much current.
I don't think you will find a replacement connector. Most just use individual spade connectors with heat shrink. I cut the melted part off mine and used a spade then plugged the rest of the plug back onto the other two spades. This was after I put in relays to prevent it from happening again.
Similar threads
