Ok a few questions to ask the Jeep ninjas on this forum.
I am finally putting everything back on my frame off restoration and I have connected everything up but I have a few questions so I can get this correct....
1. What is this connector and where does it go? ( it is on the transmission/tcase wiring harness near the vent tube)
2. Does your wiring harness touch the top of the tranny as it passes over to connect to the tcase? If not, how does it route?
3. I have read that most recommend routing the tcase breather tube to the passenger side firewall. Doesn't that put that tube awfully close to the muffler/CAT and be subjected to intense heat?
Thanks
I am finally putting everything back on my frame off restoration and I have connected everything up but I have a few questions so I can get this correct....
1. What is this connector and where does it go? ( it is on the transmission/tcase wiring harness near the vent tube)
2. Does your wiring harness touch the top of the tranny as it passes over to connect to the tcase? If not, how does it route?
3. I have read that most recommend routing the tcase breather tube to the passenger side firewall. Doesn't that put that tube awfully close to the muffler/CAT and be subjected to intense heat?
Thanks