This is for those of you who have done gears on a Dana 44. I bought a master over haul kit for my Dana 44 and it came with these oil slingers.
i know for a fact that the small black oil slinger came offfrom in between the pinion seal and yoke side pinion bearing. I don’t remember taking off the other two and they are not in the pictures that I took. I am wondering if I use the other two that I am holding and if so where do they go? It seems like the big one goes onlike this but it was not there when took the axle apart.
i know for a fact that the small black oil slinger came offfrom in between the pinion seal and yoke side pinion bearing. I don’t remember taking off the other two and they are not in the pictures that I took. I am wondering if I use the other two that I am holding and if so where do they go? It seems like the big one goes onlike this but it was not there when took the axle apart.
Last edited by a moderator: