kmas0n
I have no idea what I'm talking about 46 From Sedona, Arizona
Latest activity Postings Attachments Images About
-
-
kmas0n replied to the thread 2005 Rubicon; A Rubi Brother.Looks great. I love the AEV wheels. The Falkens are great too. -
kmas0n replied to the thread Trail_Krawler & Trail_Willys.This is probably one of my favorite type of projects... Creating sometime from nothing. Seat mounts are newbie levels of fabrication...
-
-
kmas0n replied to the thread Trail_Krawler & Trail_Willys.I've started work on the driver controls. Since the steering, and seats were long gone when I got the jeep, I am starting from scratch...
-
-
kmas0n replied to the thread Trail_Krawler & Trail_Willys.It was really fun. I'm told by some of the guys there that it's harder than upper and lower terminator. Cannot confirm personally
-
kmas0n replied to the thread Trail_Krawler & Trail_Willys.This past week I went on a ride along to Smasher Canyon, the most difficult trail in the Verde Valley. It was a lot of fun, and everyone...
-
Cottonwood AZ
-
That trail was gnarly. This is the only pic I took. We pretty much just drove and didn’t stop much unless someone got stuck...
-
kmas0n replied to the thread Trail_Krawler & Trail_Willys.Since the rear of the frame had been replaced and the rear body mounts were gone, I needed to know where to drill holes and fabricate...
-
-
My friend who is a body man says that’s just fine. I was shooting for that with a project I was asking him about. I can say that when...
-
I one heard “ He who puts the bondo on must sand it off” Don’t put too much on
-
kmas0n replied to the thread Need Help With Lower Control Arm Sizing.I feel bad for new guys like cody. Don't worry, they treat everyone like this . To answer your very simple question, Yes 2" OD 0.25 is...
-
kmas0n replied to the thread Need Help With Lower Control Arm Sizing..120 dom for the uppers will be plenty too. The uppers only receive compression/tension forces, no side to side load.
-
kmas0n replied to the thread Need Help With Lower Control Arm Sizing.2 inch 0.25 DOM will be plenty strong for the lowers, even if you are bashing it in the rocks.
-
kmas0n replied to the thread Trail_Krawler & Trail_Willys.So far I've managed to hammer and dolly everything to no more than 1/16 of an inch. I think it will look good with some body filler...
-
It looks like you’re getting the hang of sheet metal welding. Lots of fitting and tacks. If a skim coat of filler will make it look...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
