tworley
48" of travel 36 From Arvada, CO
Latest activity Postings Attachments Images About
-
-
Mine will stay raw aluminum. Now that I built the tub rails out of aluminum, I will go back and do some cleanup on the corner armor... -
The first time I took it on trail after the paint job, my passenger rear tire rubbed the edge of the armor and took the paint off the...
-
It’s a lot of work to paint match. I’ve done it and very happy with mine. I can send you the procedures in an Excell document if you...
-
Upper limit of what? That is where this discussion needs to go. Forget about the bumpstop for a minute. When I set my uptravel, I...
-
You can't really tell the gap based on the dust boot. That will move down once filled with grease. For me, I would torque the castle...
-
tworley reacted to InOmaha's post in the thread STICKY September 2023 ROTM (Ride of the Month) Contest with
Like.
-
tworley reacted to Morks's post in the thread STICKY September 2023 ROTM (Ride of the Month) Contest with Like.
-
tworley reacted to Irun's post in the thread STICKY September 2023 ROTM (Ride of the Month) Contest with Like.
-
Got some seam sealer. The guy at KC’s Auto Paint Supply talked my ear off. He knew way more than me. He was looking at my door and...
-
New water pump installed. I decided to start it up before re-installing the fan and shroud. Still had a leak. Watched for a bit and saw...
-
Some pics of my install locations. I did 10 KC Cyclones all wired in parallel to a single fuse using 18 gauge wire. For cleanliness I...
-
I’ve been working on mounting rock lights for a while now. Finally finished this morning! Mounting these cleanly took longer than I...
-
How did I arrive at 1.625" for the width, no one has asked? The corners I have are used and had Savvy tub rails on them with the...
-
It's my turn to be inspired by @starkey480. I built some tub rails! Earlier this summer, I bought ten feet of 1x2" 6061t6 aluminum...
-
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…