Towards the end I've stopped taking as many pictures- it's lots of little odds and ends that aren't that complicated.
I've got everything on the top list done:
Rear driveshaft - arrived and installed
Front driveshaft - unstuck slip joint with the liberal application of a BFH, replaced slip joint seal, and regreased
Rear shocks - Installed with teraflex mount extenders. I may need to cut the coil bucket once I do a flex test
Air lines to lockers - done
Oil in differentials and transfer case
Brake system filled and bled
Installed ebay e-brake handle - did not have one when I bought her
Installed junkyard center console - ebay wanted $300 + $300 shipping to AK, but I managed to find one local for $100.
Installed both rear fender flares
As for the bottom list:
I can't install the front fender flares until I pull the broken front bumper out, so that's on the back burner for now. Once I get it road-legal, it'll be easier to take it to a friend's house with a welder.
Locker switches mostly wired- Everything except illumination and power. The supplied ARB toggle switches do not fit in to where my hardtop switches used to be, so I'll have to figure something else out. The ARB switches also are daisychained together with their supplied harness- you can't turn on either locker without having the compressor on, and you can't turn on the front locker without having the rear locker on. I'll probably rewire it to simple toggle switches and put the panel where the coin tray/airbag switch goes. Ebay has a couple panels available, but I may try to build my own and put 8 switches on instead of the usual 5 - 3 for lockers, 2 for heated seats, 3 for something else (lights, maybe winch, maybe subwoofer).
Front bumper - really just needs to be pulled out and re-welded. I'll probably take it to a buddy's place in the next few weeks.
Winch tray - Still need to look around for one. I may need to heavily modify one- my front bumper is really built around the winch, most of the ones available seem to have a really wide mounting plate.
Rock sliders - The current front fender flares extend too far back to install the sliders. I'll probably just wait until I replace them to put the sliders on.
Subwoofer - On the back burner. I'll probably end up putting it under the driver's or passenger seat, I really like all the storage in the center console.
When I bought her there were no seats inside, no center console, and no carpet - just bare, rusted metal. It's amazing to have it looking like a real vehicle and not just a rusted out tub.