Hi All,
Currently undergoing an axle swap and need to know where to mount the three link brackets on the front axle for the Savvy mid arm. Are there any measurements to go off of? Should the top link be centered on the axle vertically and some specific distance to the driver side of the axle...
I figure it is time to start a build thread for my Jeep to consolidate my thoughts. I'm sure I'll have a lot of questions about things that don't really need to be their own threads.
A bit of back story, my Jeep is a '98 Sport purchased about 6 or 7 years ago after insurance totaled my '97...
I'm curious how the offset of an axle side link bracket affects the characteristics of a 3 or 4 link setup, specifically the position fore or aft of the centerline of the axle.
To be specific, I'm trying to see if a front axle stretch of a few extra inches is possible without replacing my...
It was mentioned to me that I ought to look at Midnight LJR's build on this forum. Which I did. Amazing job and detail on that one! I looked around a little further, read about Chris's genesis of starting the Wrangler Jeep TJ Forum, was impressed with what he had to say and have enjoyed reading...
Wondering if you could help me out with the installation of the Savvy Mid-arm (complete kit)...on my 2005 TJ Rubi.?
I'm following the on online instructions that Chris posted (https://wranglertjforum.com/threads/savvy-mid-arm-install.16426/), however, I've run into an issue with the rear...
2005 Jeep Wrangler Unlimited – 6 MT - $18.5k
Impact Orange (1 of 471 Impact Orange Unlimited in 2005)
112,000 miles
NO RUST – Nevada and New Mexico ownership prior to this year
Factory Hard Top
Bestop NX Soft Top included
Upgrades:
- Savvy Mid Arm 4 inch lift, installed by Vegas 4x4 in 2018.
-...
Specifically I'm looking at the differences in both construction and real world performance associated with the Savvy and Rockmen kits.
To be as clear as possible i'm not currently shopping for a mid-arm i've actually been looking at a full johnny joint short arm setup but am curious as to...