Drove it home and parked it. Went out next morning and motor would turn over but wouldn't hit a lick. Gauges don't move. Has never done this before. Checked and no fire to spark plug. Replaced crankshaft position module, still doesn't fire.
1997 Jeep TJ no fire
- Thread starter ArkansasTJ
- Start date
check the wiring around the crank position sensor, and also in & around the cam position sensor (near the distributor).
Swap the ASD relay with another one to check. The ASD relay provides 5V power to the crank and cam shaft position sensors
All of the above advice is gold. I had a similar crank no start situation that ultimately ended up being a loose connection at the ignition coil, pulled connector apart, cleaned it, reconnected and that was it.
My advice, do the above from easiest to hardest. In my case I didn't check that connection (easiest) until I'd tried many more difficult and costly options that didn't solve the problem.
Keep us updated, especially if you solve it.
My advice, do the above from easiest to hardest. In my case I didn't check that connection (easiest) until I'd tried many more difficult and costly options that didn't solve the problem.
Keep us updated, especially if you solve it.
