Hi all just wanted to run this by the board to see if this is a good idea.
what I was thinking of doing was putting a jack under the pinion then removing both lowers or uppers, and then lowering or raising the pinion output. Would this rotate the axle sufficiently?
Other option is to just slowly inch the 4 of them forward one at a time with a racket strap.
what I was thinking of doing was putting a jack under the pinion then removing both lowers or uppers, and then lowering or raising the pinion output. Would this rotate the axle sufficiently?
Other option is to just slowly inch the 4 of them forward one at a time with a racket strap.
Last edited: