Hey fellas,
I have had this kit for a while and I am just now getting around to wiring these lights up.
here is my issue, the loom for the relay looks to have been wired completely wrong and I can’t figure out what they are doing here.
it came to me wired as such:
red fused power from bat. With ring terminal on 87
power out to lights on 30
ground on 86
jumper from fused power wire from 87 to 85(? Huh?)
I was going to wire:
fused power from bat to 30
power out to lights ( split with bullets one to each light) on 87
ground at 86
grounds from lights to same ground screw in bumper
wire out from switch to 85
how am I supposed to wire this?
also I have a OC illuminated rocker switch that goes into the blank on my dash bezel. in the factory harness behind the bezel are there provisional power and ground wires already there? Or should I tap into the rear washer power wire and ground (already there on my Sahara)or the cig lighter, and run the switch (trigger) wire through the firewall to the relay?
all the wiring on my jeep is completely stock and unmolested.
how have you all wired these?
thanks!
I can post pics if need be
I have had this kit for a while and I am just now getting around to wiring these lights up.
here is my issue, the loom for the relay looks to have been wired completely wrong and I can’t figure out what they are doing here.
it came to me wired as such:
red fused power from bat. With ring terminal on 87
power out to lights on 30
ground on 86
jumper from fused power wire from 87 to 85(? Huh?)
I was going to wire:
fused power from bat to 30
power out to lights ( split with bullets one to each light) on 87
ground at 86
grounds from lights to same ground screw in bumper
wire out from switch to 85
how am I supposed to wire this?
also I have a OC illuminated rocker switch that goes into the blank on my dash bezel. in the factory harness behind the bezel are there provisional power and ground wires already there? Or should I tap into the rear washer power wire and ground (already there on my Sahara)or the cig lighter, and run the switch (trigger) wire through the firewall to the relay?
all the wiring on my jeep is completely stock and unmolested.
how have you all wired these?
thanks!
I can post pics if need be
Last edited: