So I ordered a Barnes skid plate. Was the best deal I could find shipped for $200.
Only thing is it comes without holes for the tranny mount.
Would it be ok just bolting the skid up and then marking the spots where the holes need to be? Jack up the tranny and bolt the plate up then drop it on the skid and mark it?
I do not want to screw it up.
Only thing is it comes without holes for the tranny mount.
Would it be ok just bolting the skid up and then marking the spots where the holes need to be? Jack up the tranny and bolt the plate up then drop it on the skid and mark it?
I do not want to screw it up.