Hi All,
I recently installed a "full" centre console into my TJ. However have got 3 problems
1 - This section is uncovered. I don't have a airbag switch and can't seem to find any available replacement parts for it. Does anyone either know what i can search for on Ebay/Ali Express etc or has something they can mock up to be 3D printed?
2 - I'm not sure if the centre console is slightly twisted, but the top plate around the shifter fits perfectly into place as it did on my old half console, however when i change gear, it pops out, as if something is twisting. There's no screws at that end of the console to hold it into place. If i click it back into place in any of the gear positions it stays in place, until i change gear again and then it pops out.
Any ideas on fixing this properly?
3 - When the lights are on, i can see the small bulb under the shift which i imagine is supposed to illuminate the shift positions. However when the plate is in place, absolutely no light comes through. What's the purpose of the bulb if not to provide backlighting?
EDIT - Yes the whole things needs a proper clean. It's on my list to take the whole dash out and clean/spray when i've got more time/space.
Cheers
Martyn
I recently installed a "full" centre console into my TJ. However have got 3 problems
1 - This section is uncovered. I don't have a airbag switch and can't seem to find any available replacement parts for it. Does anyone either know what i can search for on Ebay/Ali Express etc or has something they can mock up to be 3D printed?
2 - I'm not sure if the centre console is slightly twisted, but the top plate around the shifter fits perfectly into place as it did on my old half console, however when i change gear, it pops out, as if something is twisting. There's no screws at that end of the console to hold it into place. If i click it back into place in any of the gear positions it stays in place, until i change gear again and then it pops out.
Any ideas on fixing this properly?
3 - When the lights are on, i can see the small bulb under the shift which i imagine is supposed to illuminate the shift positions. However when the plate is in place, absolutely no light comes through. What's the purpose of the bulb if not to provide backlighting?
EDIT - Yes the whole things needs a proper clean. It's on my list to take the whole dash out and clean/spray when i've got more time/space.
Cheers
Martyn