How to make an ignition switched power distribution block?

[NskLJ]

More options itemized on their website
https://www.painlessperformance.com/wc/p.php?s=fuse7

Seems like a no brainer given my anemic skills with wiring

I don’t think you could buy the components for their prices. There is a cover for the fuse box also which would finish off he install to give it the factory look.

 

[MikekiM]

I don’t think you could buy the components for their prices. There is a cover for the fuse box also which would finish off he install to give it the factory look.

I saw the cover.. I bought the kit from Amazon and they don't have the cover as far as I can tell. I'll have to follow-up with that order from Painless

 

[KingCarGuyZ]

Yup.. I ordered the kit you linked to. The solution @KingCarGuyZ offered was simple enough, but I'll be faced with the dilemma again at some point so since I need to rewire the seat warmers, will be putting in a towing kit and a few other add ons so easier to buy the kit. Kind of the same route I went with the Auxbeam switch panel. Could have done a full DIY setup but easier to buy the kit.

after doing the full DIY kit, if I had to do it again I would buy an auxbeam, would likely have wound up being cheaper.

 

[Wildman]

I saw the cover.. I bought the kit from Amazon and they don't have the cover as far as I can tell. I'll have to follow-up with that order from Painless

Here ya go.

https://www.amazon.com/dp/B003EORWMS/?tag=wranglerorg-20