Lift kit install advice needed

[Sancho]

No holes needed to install adjustable trackbars without a relocation bracket. Though some do require enlarging the existing holes.

They are not hard to install. Besides possible enlargement of existing holes, the only other modification needed is to cut some metal from the top of the rear axle mount to allow for clearance so the axle can drop further without interference.

And if you eventually go to a DC driveshaft in the rear and adjustable upper CAs to adjust your pinion angle, you'll need to notch the rear of the lower spring perches to prevent contact with the shocks.

I was talking about the relocation brackets, based off his link... *I see I replied to the wrong post!

I assume installing the adjustable trackbar is even easier.