PSC Hydro Assist Fluid Amount

[Nick21]

I am going to be swapping over to a hydro assist setup within the next month or so, this includes a Blaine's bolt on hydro assist kit, PSC big bore, & PSC pump with Short Res. I currently have 4 QT of the Swepco 715 fluid, I just wanted to make sure that I have enough fluid.

Does anyone that has done this swap recently now how much fluid I should expect to need?

Thanks

 

[Irun]

4 qts should be plenty. I didn't add the cylinder yet, but did add a 16" cooler. I believe I used somewhere around 2.5 qts.

 

[Alex01]

Just like @Irun, I used somewhere in the neighborhood of 2 quarts.

 

[Nick21]

I will not worry about it then, thanks

 

[mrblaine]

I am going to be swapping over to a hydro assist setup within the next month or so, this includes a Blaine's bolt on hydro assist kit, PSC big bore, & PSC pump with Short Res. I currently have 4 QT of the Swepco 715 fluid, I just wanted to make sure that I have enough fluid.

Does anyone that has done this swap recently now how much fluid I should expect to need?

Thanks

Usually takes a bit over 3 quarts.

 

[Apparition]

Usually takes a bit over 3 quarts.

Is that in the instructions?

 

[Nick21]

@mrblaine - Any idea when the instructions will be done?

 

[Grant Lasson]

A little over two quarts. I've got 4 left over! (I didn't know that the PSC kit I ordered came with it so I ended up with twice as much.)

 

[Lax22]

On my system; which consists of a taped steering box, factory pump, plate cooler, and a ram from Blaine, I used just over 3 qts.