jeepndogs
TJ Enthusiast
The only angle that matters is the one where it doesn't vibrate. So, I never give anyone an angle or much of anything except to start low in the back and move it up a 1/2 degree at a time until it changes and correlate the change with what you've done and keep messing with it until you get it as good as possible. Also, with problematic rigs, I remove the front shaft so I'm only working with one set of vibes.
So on a SYI with a CV joint what would be considered low to start at? 2 degrees? 3 Degrees? Ideally I have been told and have read that with a CV joint the pinion should point directly at the joint and that the rear can be below the driveshaft but not at all high, and the opposite would be true for the front.
So @mrblaine how low would you start at on the rear shaft with a SYI?