So in trying to get my driveshaft lined up etc... I'm trying to replace the rear pinion yoke in a dana 44 went to point and spring ( a driveshaft specialty shop) and had them measure the yoke turns out its discontinued which the more I get into this jeep I just purchased I'm finding more and more wrong... the dana says 3.73 gear ratio on tag someone swapped the rear end out because previous owner welded the spider gears together.... I looked at the ring gear and did the math comes out as a 4.11 which is fine but I cannot find this pinion shaft yoke anywhere it's a 26 spline the spicer number the guy gave me is x2-4-799-1 anyone have some suggestions I wasnt planning on redoing the entire suspension system along with gear work