Hey everyone - I have deen doing a "rebuild" to my drivetrain (new timing components, cooling system, oil pump, RMS) and have decided to go ahead and pull the tranny now since I am about 50% there already. Vehicle is a 99 Jeep 4.0 with AX-15.
Do I need to support the engine towards the rear of the block when I pull the tranny or will the two front motor mounts hold it?
If so, I will need to build some makeshift brace since the oil pan is currently off. I also do not have anything other than the timing componenets and new HB on the front of the motor so I am not concerned with the fan hitting the shroud if it tilts when I pull the tranny
Do I need to support the engine towards the rear of the block when I pull the tranny or will the two front motor mounts hold it?
If so, I will need to build some makeshift brace since the oil pan is currently off. I also do not have anything other than the timing componenets and new HB on the front of the motor so I am not concerned with the fan hitting the shroud if it tilts when I pull the tranny