Novak Conversions Jeep Wrangler TJ radiator

What did you do to your TJ today?

Went to Orileys this morning and picked up the clutch master cylinder/slave cylinder kit this morning.

Had it installed and checked out in about 15-20 minutes. Didn't get to test drive it till about 15 minutes ago!!!!

Big big difference!!!!!
 
Were is that show at?

Trenton, GA.

44927_copy_600x1298.jpeg
 
All the proceeds go to Hand Up ministry. A friend on mine is on the board of directors for them.

Good food last year and hoping for a bigger turnout this year!!!!

I'm off that weekend but Levi barely limped home from Tenn. and I don't know if I will have the parts in and on by then. Trenton is a normal 2 hr drive from me, might run up without the jeep ????? The Jeep thing was crazy and not much interest in going again because of traffic and not that interesting. Rather meet up with some folks that want to ride some interesting trails but I want to make sure the jeep up to what I throw at it. I have a lot more new parts to throw at it and get it to were I think it is somewhat bullet proof !
 
Previous owner (since 05) never did anything to the jeep apparently
-scrubbed carpet, seats
- attempted to add 4 inch to seat, they sent parts that don't work
- cleaned soft top, added protection, looks like a new top!!! Went from faded grey to that factory green.
- cleaned up the vinyle windows too
- some plastic part on the linkage arm to trans broke so I couldn't get out of park. Luckily it was in my driveway. I zip tied it on... Gunna 3d print a part for it this weekend.
- went to install new headlights and lost my damn wrench adapter (when I unbolted the seats earlier) and can't find it now lol

IMG_20220901_174011.jpg


PXL_20220901_220044301.jpg


PXL_20220901_204405405.jpg


PXL_20220901_215223269.jpg
 
Last edited:
Previous owner (since 05) never did anything to the jeep apparently
-scrubbed carpet, seats
- attempted to add 4 inch to seat, they sent parts that don't work
- cleaned soft top, added protection, looks like a new top!!! Went from faded grey to that factory green.
- cleaned up the vinyle windows too
- some plastic part on the linkage arm to trans broke so I couldn't get out of park. Luckily it was in my driveway. I zip tied it on... Gunna 3d print a part for it this weekend.
- went to install new headlights and lost my damn wrench adapter (when I unbolted the seats earlier) and can't find it now lol

Well, you say you did all this but... where da pics at??
 
I'm off that weekend but Levi barely limped home from Tenn. and I don't know if I will have the parts in and on by then. Trenton is a normal 2 hr drive from me, might run up without the jeep ????? The Jeep thing was crazy and not much interest in going again because of traffic and not that interesting. Rather meet up with some folks that want to ride some interesting trails but I want to make sure the jeep up to what I throw at it. I have a lot more new parts to throw at it and get it to were I think it is somewhat bullet proof !

I'm sure this will be a mix match of all different Jeeps, it's the first time they have done this Jeep show.
I'm not sure about there ride over lookout mountain, may just end up being dirt roads and paved roads.

Having said all that I am gonna be there!!!!!!
 
  • Like
Reactions: TheBoogieman
Novak Conversions Jeep Wrangler TJ radiator