WTB: Under hood wire harness(FOUND)

Status
Not open for further replies.

Gollywomper

Professional pot stirrer
Original poster
Supporting Member
Joined
Feb 9, 2019
Messages
3,529
Location
Corning CA
Need an wire harness for a 4cyl manual.
Runs from the PDC accross engine bay to under the drivers dash. Here is the part number on the bottom of the PDC. (Relay/fuse box)

AAED1DD6-6230-41B5-90B5-2223626E71F6.webp
 
I'll check tomorrow and see what I have..you need the wiring as well?
 
That is very similar. It is a 2000 with same drive train. What are you asking for it. I will look into if there are any differences between the 98 & 00 harnesses.
 
Looks like there are some connector style changes. 🥲
Thank you for looking.
 
Looks like there are some connector style changes. 🥲
Thank you for looking.
I have 2 other ones but the stickers are gone so no way for me to determine what they are. If I was more organized I would have labeled them but I usually don't sell wiring so I don't take the time
 
  • Like
Reactions: Gollywomper
I have 2 other ones but the stickers are gone so no way for me to determine what they are. If I was more organized I would have labeled them but I usually don't sell wiring so I don't take the time
Ya no worries. DeadJeep has a few of what I’m looking for listed on eBay. Just playing the “Best Offer” game. Lol
 
  • Like
Reactions: P man
Be careful with those guys just my .02
I’ve delt with them a few times and never had any issues, in fact they were quite nice. Not that way any more?

RaysWranglers on eBay was always another seller I trusted if interested, @Gollywomper.
 
I’ve delt with them a few times and never had any issues, in fact they were quite nice. Not that way any more?

RaysWranglers on eBay was always another seller I trusted if interested, @Gollywomper.
Ya not too worried about it if going through eBay. They protect the buyers very well.
 
Just confirming with them the listing. Discription says a 99’ harness. Photo shows my harness part number for a 98. They accepted my $100 bid. Which I think is a fair price should the harness be in hood condition.
 
out of curiosity, what is wrong with the harness that's in your jeep.
Nothing. I am collecting parts for a magnum v8 swap. Having another harness the same as mine will allow me to take care of the wiring ahead of time before I start the swap.
 
  • Like
Reactions: williambmac
Status
Not open for further replies.