Forgot I still needed to weld on an exhaust hanger and mini skids for my dads Jeep. The weld to the tube isn’t perfect but it isn’t horrible swirly twirly gumdrop shit either!
Arizona Rock Crawler
- Thread starter starkey480
- Start date
A tiny bit warm for that position. Next time, instead of pointing straight in, angle upward slightly holding right at the edge of skid.
I’ve always been too cold so I’ve been working on getting them hotter. Guess I overcompensated!
Beer I prefer a bit cold; welds a bit hot, and my woman warm!
I'll add that I like my coffee hot and bitter.
Day 1 of my DCSD axle swap/midarm/outboard project is in the books!
So far the only thing that was done were the gears.
1 plasma torch later…
So far the only thing that was done were the gears.
1 plasma torch later…
Got the DCSD axle cleaned up after yesterdays cuts. Grinding these welds off between the sway bar mounts and spring perches was interesting. Got most of it off with the edge of a flap and used a die grinder for the rest.
I think I finally got what DCSD is 
Looking forward to the finished project.
Looking forward to the finished project.
I think I finally got what DCSD is
Looking forward to the finished project.
Drunk Croatian step dad
Geez, I'm headed out to look over mine.
Everything is easy, some stuff is harder than others. but, its all easy. I had a service manager that always said that. F#@k that guy.
Good luck tho Starkey, you got this! 1,2,3 go.
Similar threads
