Heavy duty phone mounts

[Steelyace]

I went with Bulletpoint.

View attachment 314518

View attachment 314519

What length arms are those? Do you remember? looking at 3 arms and trying to figure out how long I should order

 

[CMBD]

What length arms are those? Do you remember? looking at 3 arms and trying to figure out how long I should order

Those look like the standard length.

This is the short and mini.

 

[Viking Jeeper]

Those look like the standard length.

This is the short and mini.

View attachment 426512

That mount behind the grab bar is nice. Did you make that?

 

[roverhi]

Anyone have recommendations for a HD phone mount setup. I've been looking for a few days and have gotten nowhere. What mounting system did you use? Bolt on? Clamp on? Needs to hold up while crawling. Thanks

This looks like a heavy duty one for mounting radio, navigation tablet etc. Saves drilling holes in dash and allows Ramm mount hardware. It's bit pricey though. 7609291256.html

 

[CMBD]

That mount behind the grab bar is nice. Did you make that?

Thanks Yes I did.

I wanted a double ball, below the top of the dash, and to not block the vents.

 

[roverhi]

Thanks Yes I did.

I wanted a double ball, below the top of the dash, and to not block the vents.

View attachment 426531

View attachment 426532

View attachment 426533

View attachment 426534

How is the vibration with that mount?? Have my phone mounted on a metal plate attachment but the vibration driving on F'Way or road is enough to mess with vision. My mount ibought on Amazon is a fairly thin metal but your's looks like it's made out of beefier material may not suffer from the vibration. Location works ok as you can glance at it with a minimum of eyes off the road. Cup mounts or lower would mess with scan pattern.

 

[CMBD]

How is the vibration with that mount?? Have my phone mounted on a metal plate attachment but the vibration driving on F'Way or road is enough to mess with vision. My mount is a fairly thin metal so your's that looks like it's made out of beefier material may not suffer from the vibration. Location works ok as you can glance at it with a minimum of eyes off the road. Cup mounts or lower would mess with scan pattern.

The material is 10ga. This version doesn't vibrate at all. More of a slight wiggle or a bounce, but its as good as it can be at this point. The bracket doesn't deflect at all. The movement comes from the actual dash.

Im super happy with it. Probably make it a product at some point.

 

[NashvilleTJ]

Thanks Yes I did.

I wanted a double ball, below the top of the dash, and to not block the vents.

View attachment 426531

View attachment 426532

View attachment 426533

View attachment 426534

Nice work - and looks like it would clear the airbag panel.