What is good price range for a 2006 Jeep Wrangler with 90k miles?

I bought my 89 Yj for 7.2K back in 91 because it was cheaper than a new quad and I could run it more places. I bought my 05 TH rubi for 22.5K instead of a RZR at 30K plus and can still run it more places. I guaranty my TJ will outlast a RZR.
 
  • Like
Reactions: pixologics
If the engine has been taken care of (oil change as required per the owner manual, tune up etc...) I don't think so. If its never had the clutch replaced that might be required.

Here is a Rubicon with what I would call low miles.

https://www.facebook.com/marketplac...wse_serp:9ca9d784-0b2c-4cb7-be08-20cc68fedc30
I just got out of a high mileage jeep (165k) and I have also tried few under 100k miles jeep wrangler and I would say there's difference.
I can say with confidence about a high mileage toyota v6 engine but Jeep is not same. Maybe experience would vary.
 
I just got out of a high mileage jeep (165k) and I have also tried few under 100k miles jeep wrangler and I would say there's difference.
I can say with confidence about a high mileage toyota v6 engine but Jeep is not same. Maybe experience would vary.
My TJ had 115K miles when I assumed ownership. It gets 18mpg on 33's and about 17mpg on 35's after the re-gear (4.56). The prior owner didn't (at least from my observation) keep it tuned up (plugs, cap, rotor were toasted when I assumed ownership and have since been replaced) and had the in-correct thermostat so the engine ran warmer than it should. But as far as torque after the re-gear and new clutch, pressure plate, throwout bearing helped engine performance.
 
Last edited:
My TJ had 115K miles when I assumed ownership. It gets 18mpg on 33's and about 17mpg on 35's after the re-gear (4.56). The prior owner didn't (at least from my observation) keep it turned up (plugs, cap, rotor were toasted when I assumed ownership and have since been replaced) and had the in-correct thermostat so the engine ran warmer than it should. But as far as torque after the re-gear and new clutch, pressure plate, throwout bearing helped engine performance.
Maybe I got banged up Jeep. Need to try some other high mileage jeep wrangler 😇
 
Yes break even didn't bother to make any profit. I was getting too many offer way higher as well but with the issues in it I didn't have it in me to make profit or even think about it.
Now you can use your experience with that one to find a better one.
To fill you guys in. He bought a very tired TJ with a very leaky steering box (had to fill it daily) for around $8.6k. Worst thing about it was PO sprayed the whole thing with white rhino liner and it had dirt and grim imbedded in it with some spots scraped off. Also the rusted frame had been repaired by a inexperienced welder.
That kind of money won’t buy you much here in SoCal unless you get lucky.
 
  • Like
Reactions: pixologics
A little off topic, but has anyone priced pick up trucks lately? WOW! Like previously stated, I think as gas prices rise, we may see a little bit better priced trucks.

As far as TJ's, I don't see a pricing going down moving forward for reasons already stated.
 
Now you can use your experience with that one to find a better one.
To fill you guys in. He bought a very tired TJ with a very leaky steering box (had to fill it daily) for around $8.6k. Worst thing about it was PO sprayed the whole thing with white rhino liner and it had dirt and grim imbedded in it with some spots scraped off. Also the rusted frame had been repaired by a inexperienced welder.
That kind of money won’t buy you much here in SoCal unless you get lucky.
I have to see pics or it never happened. :)
 
I have to see pics or it never happened. :)
Sorry no pics jeeps gone to new owner. As for the frame repair just think of handing your wife the welder and tell her go at it.
Crapy Jeeps are like crapy boats. When they’re sold both seller is happy to see it go and the buyer is happy with they’er new toy until reality sets in.
 
Don't shame me 🤕
Just a sample

IMG20210304170831.webp
 
Sorry no pics jeeps gone to new owner. As for the frame repair just think of handing your wife the welder and tell her go at it.
Crapy Jeeps are like crapy boats. When they’re sold both seller is happy to see it go and the buyer is happy with they’er new toy until reality sets in.
I bought a Jeep and I described the frame repair job as looking like chewed bubble gum welds. It was the only Jeep I ever bought that I didn't look at the frame. The outside looked great and it had under 100,000 miles. I sold it for a $1,000 profit ($7,000) and the guy I sold it to, sold it 6 months later for $9,000. I showed him the crap weld job and he didn't care. He just wanted it to flip.
SAHARA%20JEEP4 (2017_11_20 00_38_12 UTC).jpg
 
Don't shame me 🤕
Just a sample
Ouch! That reminded me of an old Frankenstein movie. Did the inside of the frame look like this?

View attachment 236990
I didn't look at it with that much love. I am sure if there is rust all frame will have such kind of pattern which is a property of iron/steel when rusted over a period of time. Some more some less.
it's not like that it was going to fall of break into pieces. But putting money into repair of such thing and leaving foundation in bad shape was no for me.
I bought a Jeep and I described the frame repair job as looking like chewed bubble gum welds. It was the only Jeep I ever bought that I didn't look at the frame. The outside looked great and it had under 100,000 miles. I sold it for a $1,000 profit ($7,000) and the guy I sold it to, sold it 6 months later for $9,000. I showed him the crap weld job and he didn't care. He just wanted it to flip.
View attachment 236991
That's the way it is with someone who just wants to flip looking at the craze around brand.
I still get text messages from earlier enquirer if it's available. It's the Jeep brand and it's fellowship.
 
2004 bone stock 5 speed Rubi 18 months ago for $9500

159000 miles but owner had everything serviced at the dealership on the recommended schedule

I didn’t realize at the time but I’m so glad it was stock without having to undo all the POs decisions
 
  • Like
Reactions: Ron505
My brother bought a new Ford F-150 Ecoboost and put a computer tune in it. It now puts out over 500 HP. Twin turbo power. :cool:
Sorry, my post should have read "used" trucks. They're insanely priced. Sounds like a fun truck! Lightweight with over 500hp is just fun. Mines a bit heavy, but is over 500hp as well. Denali Duramax.
 
Sorry, my post should have read "used" trucks. They're insanely priced. Sounds like a fun truck! Lightweight with over 500hp is just fun. Mines a bit heavy, but is over 500hp as well. Denali Duramax.
I bet yours makes you wish your Jeep rode like that. :love: Nope. never going to happen.
 
  • Like
Reactions: Ron505
Sorry, my post should have read "used" trucks. They're insanely priced. Sounds like a fun truck! Lightweight with over 500hp is just fun. Mines a bit heavy, but is over 500hp as well. Denali Duramax.
Just paid $34,000 for a truck with 94000 miles...I would’ve laughed you out the room 3-4 years ago if you told me I’d do that
 
  • Like
Reactions: Ron505