Ordered a Swayloc!
Big Baller.
What did you do to your TJ today?
- Thread starter LJRubiconGuy
- Start date
Big Baller.
If you have a iphone you can get an angle finder app , works good . Just don't break your phone LOL !
Shipped my LJ from Hawaii to SoCal. Ran fine in Kona and Cal but wouldnāt pass smog check in Cal and had the blinking CEL. Took it to a dealer and they did the power module modification, no charge and without a fuss. Did have them purge brake system which wasnāt cheap. Passed Smog no problem after the mod. They did suggest I find a TJ specialist as they had no one with experience working on them.
Just tryin to keep up with you guys and your big tyres
Get lockers. You too could follow our mid-western farmhand friend. That dude is nucking futs.
I put this on since the skid plates are off. No oil spill repeats.
I'd be pissed off too if you moved me from Hawaii to Cali.
How long has it been? The last couple of years have seen the influx of out of staters -congestion is significant now. I keep this picture to show what a traffic jam used to look like on my streetā¦
my kids just bought a 1950ās 2br 1 bath starter homeā¦300k in Meridian.
ļæ¼
Lol been yL
eah
How long has it been? The last couple of years have seen the influx of out of staters -congestion is significant now. I keep this picture to show what a traffic jam used to look like on my streetā¦
my kids just bought a 1950ās 2br 1 bath starter homeā¦300k in Meridian.
ļæ¼
Well I grew up there, went to Meridian HS, (graduated in '86). We move to N, ID about 9 years ago at this point. In HS, I had to drive CLEAR out to 10 mile and go help my cousins buck hay. When I moved, we lived on Black Cat and I had to drive in a mile to go see those same cousins. ;-)How long has it been? The last couple of years have seen the influx of out of staters -congestion is significant now. I keep this picture to show what a traffic jam used to look like on my streetā¦
my kids just bought a 1950ās 2br 1 bath starter homeā¦300k in Meridian.
View attachment 400251
Pantera99
TJ Enthusiast
Installed inner shift boot. Pretty much jacked up the shifter knob getting the insert out to reach the nut. Dremeled it a bit so it's at least smooth & usable.
Found out the plastic trim is a bit small since its not a stock console. So just put the old outer boot back in place for now. It's not torn, just old & sitting in there. Hafta rig up something to make the plastic trim catch in there somehow.
Found out the plastic trim is a bit small since its not a stock console. So just put the old outer boot back in place for now. It's not torn, just old & sitting in there. Hafta rig up something to make the plastic trim catch in there somehow.
Kiwi TJ
I don't suffer from insanity I enjoy every minute
Supporting Member
Ride of the Month Winner
Went for a short cruise Sunday afternoon. A little bit of rain so I had the roof back on but only for about 20 minutes so then I could cook my sausages.
Found a steep muddy trail through the woods that I haven't been on in 20 years. Looks like they widened it a bit. It used to tear up your paint trying to get through it to get to the river crossing.
p.s. No hillbillies shot at me either.
p.s. No hillbillies shot at me either.
SPECWAR
TJ Enthusiast
Not mine but I am doing the work to frame swap and going from 4 squirrels powering this to 8.
Swapped my steering wheel which had some cracking at the top and was turning into a sticky mess with one of those recovered ones from the Poland ebay seller:
Nice. Is it thicker than the original?
Yes, I contacted the seller about a different wheel he had, and he said he could make one for me, so it is slightly thicker than the stock wheel.
After a week of stops and starts, I finally got everthing put together and we are a 2 car family again. So I'm cleaning the garage and putting stuff away. I'll rotate the axle tomorrow and measure for the new driveshaft.
