crank no start

Hello fellow jeepers. I am struggling with a crank no start issue on my 2004 TJ 4.0 A/T. I know there are plenty of preexisting threads on this topic but none seem to match up with what I have going on. Vehicle died while driving would not start back up. Upon cranking it seems to want to fire...

Hi i am in need of some help, I have a 97 tj 2.5 5 speed it will crank but not start. it was throwing codes p0320. i have replaced the following parts: coil, crankshaft sensor, cam shaft sensor, emc, plugs and wires, rotor cap and bug, map sensor, relays, fuses, fuel regulator, electric...

I have a 1999 4.0 jeep tj sport with the 32rh. i have now swapped everything out for a 1995 ax15 transmission. everything is bolted up perfectly fine and i am running into a crankshaft position sensor issue. I bought a new sensor for it and it will fire for about 1 second before immediately...

I do not own a wrangler... What I have is a 1991 Cherokee XJ 2.5L manual 5 spd, no abs, no a/c, no rear wiper, crank windows, manual mirrors, manual seats, and idiot lights and no tach, just the dumb shift light that thinks it should be a 6 spd lol. and she had 094k when I bought her. Ive put...

Hello all, I am in need of assistance. Found some frame rot on my jeep and parked for a bit and was starting it every couple of weeks by the 2nd or 3rd time it just cranked and no start. I have my 5 volt reference to the crank sensor. My ASD relay and fuel pump clicks when keyed on. I tried...

so long story short, went to replace throttle cable then went to start and test out, didn't realize cable was too short and started it up with intake slightly open heard a loud click/clank, got cam/crank sensors not synched, pulled opda and replaced just to be sure, did tdc and all, now got a...

So I have been rebuilding my 02 TJ after a wreck I had several months ago. I got an 05 donor jeep, (yes a lot of things are different), but I mainly just wanted to switch put my motor and tub on it. But ended up using the wiring harness and pcm too because of the 6spd and a few different things...

I’ve read every forum on here and still haven’t found an answer. Drove ‘99 jeep tj manual i6 just fine and then the next day.. Crank no start. No codes. No pressure at schrader valve. Changed fuel pump. Have 60psi at schrader. Changed the cam sensor. Nothing. Went ahead and changed the whole...