electrical connector

Hi, It's my first post on these forums, so if I'm not in the correct place, please excuse me, I'll try to get in the right place next time! I'm just starting to get into Jeeps, got my TJ about 5 months ago. Planning on doing a Teraflex sye kit so that I can remove the skidplate spacers and I'll...

I am in the process of replacing the dash and most of the interior pieces in my 1997 TJ. I have removed all of the dash wiring and have found some issues that I cannot overlook. I have not been successful in finding a vendor that offers a replacement wiring harness for the 1997 TJ (either...

Hey all, I've been searching the internet for days trying to find information on the dash switches for factory locker / hard top switches. The switches are available on eBay, as are some connectors. I want to know if all switches / connectors are the same between functions (locker, rear wiper...

I just replaced my fuel pump, on my 1997 Jeep Wrangler Sport with a inline six, and when I was reconnecting the fuel pump to the connector on the Jeep the red locking clip does not work. I messed with it for awhile and can get it to slide when its not connect but doesn't slide to lock the two...

Hi! My turn signal stopped working and I discovered that this switch was corroded and burned out. It was actually sparking! I cut it out and taped up the ends for now. I'm looking for a replacement. I've attached a picture of what I need. It's the smaller 4 wire plug that goes into the turn...

So I was reading yesterday about installing cruise control using the factory plug that is in some 03-06 wranglers. I found this plug and I am not sure what it goes to. My two guesses is cruise control plug (crossing my fingers) or the plug for the hood dome light.

Hey there! I'm digging in my new-to-me 97 SE, trying to figure out some electrical issues. Any idea what these connectors might be for? There are a few plugs that seem factory near the disributor/dip stick area. My TJ doesn't have abs, or A/C. Thanks!

What's the trick to this electrical connection?? It is actually the neutral safety switch for the clutch pedal. I'm replacing the entire slave master cylinder system.