Canadian rye is good. Although I prefer a blended Canadian whiskey………
RC is good.Canadian rye is good. Although I prefer a blended Canadian whiskey………
So now that we have definitively resolved the steel vs aluminum question, can some one help me decide on .45 or 9mm?
So now that we have definitively resolved the steel vs aluminum question, can some one help me decide on .45 or 9mm?
That actually sounds really good. Everything except the part about Blaine.Heading out to the kitchen now.
Would anyone like an egg salad sandwich ?
Free Range eggs, Hellman's Real Mayonnaise, green onion, ground pepper, dash of curry powder . . .
All on a toasted whole wheat crusty roll.
Big dill pickle.
mrblaine will bring the tray out . . . . .
And............. 10 mike mike for the win!As for 9 vs .45, if it's your only pistol I would purchase the 9 mainly for target practice cost. Also the picture below convinced me to go with the 9mm.
Ballistic gel
View attachment 301037
She looks fairly content. Wonder what else you could've ordered?Well while mama was preoccupied with the new grandbaby I ordered the 3/8” UCF skid. Lol.
View attachment 301999
Was it the 2” drop?I showed here a YJ crawler for sale down the road from here. She said no…… when I told her I ordered the skid she just smiled. Not sure if at me or the baby, but I didn’t ask. Lol
Excellent timing. When a women is holding a baby. Shame on you!Well while mama was preoccupied with the new grandbaby I ordered the 3/8” UCF skid. Lol.
View attachment 301999
The no body lift skid.Was it the 2” drop?
Yep thats the one I have, before the Atlas install I ran it with OEM trans mount, standard SYE, and no body lift as advertised.The no body lift skid.
What did you run after the atlas?Yep thats the one I have, before the Atlas install I ran it with OEM trans mount, standard SYE, and no body lift as advertised.
Kept the same skid just cut the trans mount channel out.What did you run after the atlas?
I’m going to run it with a mml.
For the frame attachment? I would use grade 5 or better hex head cap screws with a stainless washer. For engine skid to TC skid, countersunk flat head stainless.Should I use regular hex head bolts or Button head bolts?